Takeuchi TB108 Operators Manual
Takeuchi Tb108 Compact Excavator Workshop Service Manual
SAFETY ALERT SYMBOL
This symbol means Attention! Be Alert! Your Safety Is Involved.
The message that follows the symbol contains important information
about safety.
Read and understand the message to avoid personal injury or death.
■ It is the owner or employer’s responsibility to fully instruct each operator in the
proper and safe operation of all equipment. All persons using this machine should
thoroughly familiarize themselves with the following sections.
■ All operators must be instructed on the proper functions of the excavator before
running the machine.
■ Learn and practice correct use of the machine controls in a safe, clear area before
operating this machine on a job site.
It is your responsibility to observe all pertinent laws and regulations and to follow the manufacturer’s instructions on machine operation, inspection and maintenance.
Virtually all accidents occur as the result of a failure to observe basic safety rules and precautions.
An accident can often be avoided by recognizing potentially hazardous situations beforehand. Read and understand all of the safety messages which explain how to prevent these accidents from occurring. Do not operate the machine until you are sure that you have gained a proper understanding of its operation, inspection and maintenance.
Takeuchi TB108 Operators Manual
Engine Covered:
0.569L 2-Cylinder Vertical In-Line, 4-Cycle, Water-Cooled Yanmar 2Tnv70-Ptb Diesel Engine
Contents:
General Information
Specification
Tightening Torque
Machine Configuration
Hydraulic Units
Drive System
Control System
Troubleshooting
Engine Service
Disassembly The Engine
Engine Assembly
Piston-Oil Pan-Breather
Cooling System
Lubrication System
Fuel System
Electrical System
Draining Engines
External Components
Cylinderhead-Valves
Thermostat/Timing Gear
Starter System
Gear Reduction System
Alternator System
Fuel Injection System
Governor System
Electrical Wiring
Service Standard
CONTENTS
Introduction
Machine Description
Safety
Controls
Operation
Transport
Maintenance
Troubleshooting
Specifications
Options
Index
General precautions
Preparing precautions
Starting precautions
Operating precautions
Stopping precautions
Transporting precautions
Maintenance precautions
Safety signs (decals).
Observe all safety rules
¡Operation, inspection and maintenance of this machine must be performed only by
a trained and qualified person.
¡All rules, regulations, precautions and safety procedures must be understood
and followed when performing operation,inspection and maintenance of this
machine.
¡Do not perform any operation, inspection and maintenance of this machine when
under the adverse influence of alcohol,drugs, medication, fatigue, or insufficient
sleep.